I started off by deciding where my reflectors are going to go. Strange you may say but I need to get a small bracket welded on the nudge bar to hold them so I want to be ready if the opportunity arises to get some welding done....which it may do as I want to get my exhaust outlets made less dangerous by having a 5mm bar welded around the edge.
I made up prototypes which are shown below, I think I have finally decided, the layout in the bottom 2 pictures below.
I then finished of the nearside exhaust, fitted a couple of dome head nuts to the rubber mount and drilled holes in the collector. I will tap some holes in the headers to take some M5 bolts to hold the collector and header together.
I think I can get around it by extending one of the harnesses which I have some excess coiled up behind the dash. Very annoying and will take some time but not the end of the world.
That will be the first job next time.