My delivery of Speedflow hoses and connectors arrived on Friday so in-between sorting out the garden I have sneaked into the garage and stated to fit them.
First job was to drill holes in the firewall for the heater hose bulkhead fittings.
This was followed by the trial fitting of one of the heater hoses.
First job was to drill holes in the firewall for the heater hose bulkhead fittings.
This was followed by the trial fitting of one of the heater hoses.
Below is the view from behind the dash
Next was the fitting of the fuel hose from the pressure regulator to the inline filter. I had ordered a straight connector but upon try out a 45 degree connector was clearly needed . More expense and waiting
I then started the connection of the brake fluid reservoir to the 2 master cylinders
I then fitted the hose between the clutch master and slave
Finally I fitted the revotec fan temperature controller have finished off the 3 way super seal connector that connected it to the forward harness.